Optimum 3403020, Руководство по эксплуатации

Страница: 52 / 102

Operation
Version 1.0.2 - 2020-07-20 52 Translation of original instruction
TM3310 | TM3310D EN
T
M
3310_
GB_4
.f
m
4.19 General operating instructions
4.19.1 Clamping long workpieces

through the hollow shaft of the spindle
CAUTION!
Long rotating parts that protrude from the hollow shaft of the spindle must be secured
by the operator using suitable covers. A cover can be a sleeve that is mounted on the
headstock that, as a permanent safety device, completely covers the protruding
workpiece.

between the tips
CAUTION!
Long workpieces must be additionally supported. They are supported by the tailstock
sleeve and, if necessary, a rest.

with a lathe dog
CAUTION!
When clamping workpieces between the tips of the lathe while using a lathe dog, the
existing lathe chuck protection must be replaced with a circular lathe chuck protection.
4.20 Mounting of rests
Use steady rest or follow rest to support longer parts and prevent the workpiece from flapping
around and flying away.
CAUTION!
When mounting a rest, the rest is due his function near the top slide, which results in
additional crushing and shearing points between the guide of rest and the workpiece.
Increased attention is therefore absolutely necessary when working with an rest.
4.21 Tailstock
The tailstock quill is used to hold the tools (bits, centres, etc.)

Clamp the required tool into the quill of the tailstock.

Use the scale on the sleeve to re-adjust and / or adjust the tool.

Clamp the quill with the clamping lever.

Use the hand wheel to move the sleeve back and forth.
The quill of the tailstock is useable with a drill chuck with countersinking tools.
INFORMATION
Use the longer fixed centring point from the delivery, so that the centring point can be
pressed out again from the tailstock sleeve.
INFORMATION
When using different tools, it can happen that you cannot start with the quill marking
with scale value 0, because the tool is already ejected in this position by the expulsion
flap. In such cases we recommend to start at a value of 10mm and to convert from here
on.