Optimum 3403020, Руководство по эксплуатации

Страница: 25 / 102

Version 1.0.2 - 2020-07-20 25 Translation of original instruction
TM3310 | TM3310D EN
T
M
3310_
GB_3
.f
m
3.6.5 Aligning the machine
Once the bases are in place proceed to level according to the following description:

Fit precision spirit levels on the cross slide.

Position the carriage on the centre of the bed and, using the four end adjusting screws,
adjust until the machine spirit level displays an approximate value.

Move the carriage to the headstock and then to the tailstock and align the machine simulta-
neously with the adjusting screws until the machine spirit level shows a value of 0.05mm/m.

Adjust the adjusting screws until they place pressure but do not vary the levelling.

Lock with nuts and check the levelling again.
3.7 Cleaning the machine
ATTENTION!
Do not use compressed air to clean the machine.
Your new lathe must be completely cleaned after being unpacked to make sure that all the
moving parts and sliding surfaces are not damaged when the machine is operated. Each unit
leaves the factory with all its polished parts and sliding surfaces suitably greased to avoid oxi-
dation in the period of time that elapses, until it is started up. Remove all the wrapping and
clean all the surfaces with a degreaser to soften and remove the protecting greases and coa-
tings.
Clean all the surfaces with a clean cotton cloth and lubricate the lathe as explained in the follo-
wing section, before connecting the power and beginning to operate the machine.
3.7.1 Lubrication
The lubrication and initial greasing of your new lathe consists of
checking the oil levels through the headstock, apron and feed box oil
sight glasses. The oil tanks must be filled to half way up the sight
glass. Only afterwards can the machine be placed into operation.

The headstock and feed box oil must be changed 150 hours
after being filled for the first time, then after every 2000 hours of
operation.

Use the oil types recommended in the reference table . The table
shows a list of well-known companies and brands for oils that
meet our specifications. This table can be used to compare the
characteristics of each different type of oil of your choice.

Lubricant on page 92

The lubrication nipples must be lubricated every 8 hours using an oiler. Furthermore, it is
also recommended to lubricate the slide tracks of the machine bed once a day.
3.8 One-component paint
The machine is lacquered with a one-component paint. Take this criterion into account when
selecting your cooling lubricant and cleaning the machine.
A one-component lacquer with solvent part hardens when the solvent evaporates.
As soon as the lacquer is applied the solvent evaporates into the air. The binder becomes fel-
ted and a dry film is formed. This process is reversible, i.e. the binder can be etched again and
again.
Two-component lacquer also consists of binder and solvent. However, the paint only dries
when a setting agent is added. This process is not reversible, i.e. the binder cannot be etched
again and again.
The company Optimum Maschinen Germany GmbH does not assume any guarantee for sub-
sequent damages due to unsuitable cooling lubricants.