Optimum 3338131, Руководство по эксплуатации

Страница: 45 / 72

Version 2.5.1 - 2020-7-28 45 Original operating instructions
TU1503V | TU2004V | TU2304V | GB
Adjust
ing_
co
nt
rol-b
oard
_
BA-
int
egra
ted
_GB
.f
m
5.3.2 Setting instructions control board
Please find below a description to set the operating parameters, if required after replacement of
the control and of the motor.
Vmax
This is the potentiometer to set the maximum possible speed of the motor.
The speed of 3000 min
-1
must not be exceeded since the spindle bearings and your tools might
get damaged.
Vmin
This is the potentiometer to set the minimum possible speed of the motor. Make sure that the
speed does not fall below 50 min
-1
.
With reduced speed also the torque (power of the motor) and the cooling will reduce!
Torque
This is the potentiometer to set the torque when readjusting the motor. Depending on the
application set the value by which the the control will readjust. If you require less readjustment,
turn the potentiometer one to two turns in direction "minus". For a larger readjustment, turn the
potentiometer in direction "plus". For thread cutting we recommend little torque.
Slope
This is the potentiometer to set the acceleration time of the motor at the moment when it starts
turning. If you require a smoother ramp, turn the potentiometer in direction "plus". In order to
achieve a steeper ramp, turn the potentiometer in direction "minus".
CL
This is the potentiometer to set the current limiting as an overload protection for the motor. The
current limiting is set by the manufacturer and must not be changed in any way.
WARNING!
The control is charged with high constant-voltage currencies. Please make imperatively sure
that the housing will only be opened up in the idle status. Furthermore, make sure that any
settings are only being performed when the housing is closed.
General
The spindle trimmers of the potentiometer are designed with 12 gears. This means in order to
achieve the corresponding minimum or maximum value, the spindle trimmer needs to be turned
12 times. Due to this high number of gears of the spindle trimmer it is possible to perform a very
sensitive setting over the corresponding potentiometer.
Fig.5-6: Control board
- +
- + + - + -
+ -
CL
Slope
Vmin
Vmax
Torque
Vmin
Vmax