Appendix
Version 1.1.2 - 2022-02-24
82
Translation of original instruction
S 131 GH
EN
S131
GH_GB
_9.
fm
8
Appendix
8.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
Term
Explanation
Workpiece
•
Material to be cut
Blade guide pulley
•
Pulley through which the saw band passes in the saw arch
Saw arch
•
Housing with protective cover for the saw band
Material stop
•
Position for multiple cuts
•
Sawing stop
hydraulic cylinder
•
Hydraulic lowering cylinder
•
Hydraulic feed
Feed regulation valve
•
Valve on the hydraulic cylinder
Protective cover of the V-
belts
•
Covering cap of the pulley
Protective cover saw arch
•
Cover on the rear of the saw arch
Blade guide bearings
•
Rollers between which the saw band passes
•
Guide bearing
Saw belt guide
•
Blade guide bearings
Saw belt brush
•
Dirt wiper
•
Cleaning brush of the saw belt
Clamping jaw
•
Strip terminal on the machine vice
Machine vice
•
Clamping device for the workpiece
Drive motor
•
Engine
