Optimum 3290360, Руководство по эксплуатации

Страница: 38 / 92

Operation
Version 1.0.3 - 2020-10-13 38 Translation of original instruction
SD351AV
EN
SD351A
V_G
B
_4.
fm
4.3 Workpiece clamping
ATTENTION!
If sawing is carried out without using the workpiece clamp or with insufficient clamping
effect, the workpiece may be ejected, which can lead to injuries. The workpiece clamping
must be used without exception. If the clamp cannot fix the workpiece sufficiently, the
machine must not be used.
Always clamp the workpiece in the most stable position. At this, the shape of the workpiece is
influencing the orientation which allows a safe clamping.
The figure below shows the recommended type of clamping using standard workpiece geome-
tries:
Img.4-6: Workpiece clamping
4.4 Switching the machine on

Switch on the master switch.

Set rotary switch to „
I
“.

Wait until the operating pressure of the hydraulic unit is
reached.
4.4.1 Manual" machining

Place the workpiece in the desired machining position.

Clamp the workpiece by pressing the "Close" push button.

Use the rotary selector switch to set the "Manual" operating mode.

Switch the rotary switch of the lowering valve to "ON".

Use the "Lower" push button to move the saw bow just before the part to be cut.

Set the desired saw band speed and feed rate.

Press the "On" push button to activate the saw band run.

Press the "Lower" push button. The saw arm moves downwards and saws the workpiece
until it reaches the lower end position. When the material is completely sawn, the metal belt
saw will be automatically switched off by the end position switch . Then it is also positioned
on the mechanic limit stop.

Lift the saw bow with the "Lifting" push button.

Close the lowering valve.