Troubleshooting
The display shows black screen.
- Ensure that all plugs and jacks used by external power supplies (both
Opticis and others) are firmly connected. Ensure that the related LEDs are
ON.
- Ensure that the transmitter and receiver are plugged correctly to a PC and
display, respectively.
- Check if the PC and display(s) are powered on and properly booted.
Screen is distorted or displays noises.
- Check if the graphic resolution is properly set. Go to the display properties of
Windows and tap the settings.
- Ensure that the resolution sets less than WUXGA (1920x1200) at 60Hz
refresh ratio.
- Reset the system. Disconnect and reconnect the optical fiber or 12V power
adapters.
Maintenance
No special maintenance is required for this and power adapters. Ensure that
the power adapters are stored or used in a benign environment free from
liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis.
Technical Support and Service
For commercial or general product support, contact your reseller. For
technical service, contact Opticis by email
website at www.opticis.com
1-6 Troubleshooting, Maintenance, Technical Support
Switch operation guide
Graphic data is always transmitted not only to Local Display but also to
remote DVI OUT. However, USB port for keyboard and mouse is selectable
for control at specific position.
Local control
- Set the switch on the front of the Transmitter to the Local side, and the
Local LED (blue) of both will be turned on.
- Then, you can control a PC at local side through the display, connected to
the Local Display port of the Transmitter.
Remote control
- Set the switch on the front of the Transmitter from the Local side to the
Remote side, and the Remote status LED (blue) on the front side of both
Transmitter and Receiver will be turned on.
- Then, you can control a PC at remote side through the display, connected to
the DVI OUT port of the Receiver.
Console Switch and Indicator
- Connect the Console port in both Transmitter and Receiver to the RJ11 port
in both Console switch (LSKP-1003) and Indicator (RSKP-1003) over each
one (1) console cable.
-
Set the switch on the front of the Transmitter to the Console side.
- Then, you can control by setting the switch (Local or Remote) on the LSKP-
1003. If you set the switch to the Local, the Local status LED (Green) of
LSKP-1003 and (Red) of RSKP-1003 will be turned on, and you can control
a PC at Local side.
On the contrary, if you set the switch from the Local to the Remote, the
Remote status LED (Red) of LSKP-1003 and (Green) of RSKP-1003 will be
turned on, and you can control a PC at Remote side.
1-5 Switch operation guide
