Step 5
Plug the transmitter to the DVI receptacle of the DVI source such as PC and the
receiver to the DVI receptacle of the display.
Figure 4
– Connection of the transmitter to the DVI source and receiver to the display
Note:
Be recommended NOT to use any intermediate cable or adapter between
them to avoid undesirable performance degradation.
Step 6
Make the PC and the display power ON. And ensure that the Status LED in
transmitter and receiver turn on.
1-4 Installation
DVFX-100
Transmitter
DVI Source
DVFX-100
Receiver
DVI Display
Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug the 5V power adapters to the power jack of the transmitter and receiver.
Ensure the Power LED ON (Blue).
Figure 2
– Connection of power adapter to the transmitter and receiver
Step 3
Please, check if the maximum resolution of the display is UXGA (1600x1200).
Otherwise, follow the instructions for
Self-EDID Programming Procedure
on
page 1-5.
Step 4
Connect SC optical fiber between the transmitter and the receiver as shown in
figure 3.
Figure 3
– Connection of optical fiber
1-3 Installation
One (1)
Optical Fibe
r
DVFX-100
Transmitter
DVFX-100
Receiver
