Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug and fasten the 5V power adapters to the
+5V DC
jack on the rear side of
converter. Ensure the Power LED ON (Blue).
Step 3
Connect the S-video or Component video source to SVDF-200 over mini-DIN
or RCA cable. Please make sure the firm connections between video source
and input port of converter (
S-VIDEO IN and COMPOSITE IN).
If the
connected video source is active, status LED (Blue) will be turned on.
[Note 1] SVDF-200 is designed to accept the first incoming video inputs. If the user
connect Composite video output to SVDF-200 input port, it will work as composite video to
1-fiber DVI converter and vice versa.
Step 4
Connect the
OPTICAL OUT
to 1-fibe DVI receiver, DVFX-100-R over multi-
mode SC-SC optical fiber.
Step 5
Plug DVFX-100-R to DVI input port of display.
Step 6
If you need on-site monitoring, connect
S-VIDEO OUT or COMPOSITE OUT
on the front side of converter to dedicated local display over mini-DIN or RCA
cable.
[Note 2] As the same concept as Note 1, if f the user connect S-video output to SVDF-200
input port, it will work as S-video to 1-fiber DVI converter and only S-VIDEO OUT port
would be activated.
1-3 Installation
Note1:
The maximum extension length by multi-mode fiber is 500 meters.
Note2:
Be recommended NOT to use any intermediate cable or adapter in
between to avoid undesirable performance degradation.
Figure 1
– Connection Diagram of SVDF-200
1-4 Installation
S-video / Composite video
Source
Local
S-video / Composite video
Display
One
(1) O
ptical Fiber
DVFX-100
Rx
Remote
DVI Display
at SXG
A
SVDF-200
