Product Specifications
Compliance with HDMI standard:
supports HDMI 2.0
Extension limit:
200m (656feet) for 4K (4096x2160) at 60 Hz
refresh rate
over one (1)
LC OM3
fiber (50/125um).
Graphic Transmission Bandwidth:
Supports total data rate
18Gbps (6Gbps per lane).
Supports
HDR at 10bit or 12bit speed
respectively within 18Gbps
Extra Copper Extension
available up to
2m
on each side (TX/RX)
Supports
ARC up to 200m
Selectable Option: full compatibility with
HDFX-500-TR
as a pair
Firmware upgradable
via micro USB port
Support
CEC, EDID, and HDCP 2.2 / 1.4
Mechanical specifications of transmitter and receiver
Dimensions
(WDH)
:
39mm x 76mm x 20mm
Environmental Specifications
Operating temperature: 0°C to 50°C
Storage temperature: -30°C to 70°C
Humidity: 10% to 85%
AC/DC Power Adapter
Power Input:
AC 100-240V, 50/60Hz.
Power Output:
+5 V, 1A SMPS DC-power Adapter
LED indicator
Status LED
RED:
No connection with the Fiber
AMBER:
No data signal
GREEN:
Signal ON
BLUE:
ARC ON
Power LED
BLUE:
Power connected
1-6 Product Specifications
Troubleshooting
The display shows black screen
.
□
Ensure that all the plugs and jacks used by DC power supplies are firmly
connected. Ensure that the LED is ON.
□
Ensure that the HDMI cables are firmly plugged into the HDMI source and
display.
□
Ensure that the transmitter and receiver modules are plugged correctly to the
source and display, respectively.
□
Check if the HDMI source and display are powered on and properly booted.
□
Reset the system by de-plugging and re-plugging the transmitter or receiver,
or by de-plugging and re-plugging the DC power adapters that are plugged to
the transmitter and receiver module.
□
Re-boot up the system while connecting the module.
Screen is distorted or displays noises.
□
Check if the graphic resolution is properly set. Go to the display Properties
and tap the Settings. Ensure that the resolution sets less than WQUXGA
(3840x2400) at 60Hz refresh ratio.
□
Reset the system.
□
Power down, disconnect and reconnect the optical system cable or DC power
adaptors, and power up again.
Maintenance
No special maintenance is required for the optical system cables and power
supplies. Ensure that the cables and power modules are stored or used in a
benign environment free from the liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to Opticis
or its authorized distributor.
Technical Support and Service
For commercial or general product support, contact your reseller. For technical
service, contact Opticis by email
1-5 Trouble Shooting, Maintenance, Technical Support and Service
