OPTICAL SYSTEMS DESIGN
DOC ID: 10115303
OSD2251P OPERATOR MANUAL
PAGE 22
2.5.2
COMMAND LINE FUNCTIONS
There are a number of command line functions that enables the user to obtain running information of a
single OSD2251P unit or the complete topology of the ring/bus network. This section explains the
command lines and its functions.
When the terminal emulation program is operating, connect the USB cable to any one of the
OSD2251P units on the ring/bus network – or alternatively, the OSD2251P unit which the user wishes
to interrogate. Note: A message will be displayed on the terminal emulation program when the unit is
powered after USB connection. This message will not open when the unit is switched on while
plugging in the USB cable, however the command lines are functional.
The following table outlines the user available command line commands and their functions
TABLE 6: TERMINAL COMMAND LINES
TERMINAL
COMMAND
LINE
SPECIFICATION
FUNCTION
FIGURE
help
help
Displays all user available CLI commands
-
tc
Topology Check
Displays the topology status of the
established ring/bus
Figure 18
nc
Node Check
Displays the running status of the node
with given MAC address
Figure 20
lnc
Local Node Check
Gets running status of the local node
Figure 21
fbe
Float Backup Enable
Enables float backup function for all nodes
on the ring/bus
Figure 22
fbd
Float Backup Disable
Disables float backup function for all
nodes on the ring/bus
Figure 26
vc
Version Check
Displays the current software version and
revision installed on the unit
Figure 29
