OPTIARC CD-1100, Руководство по эксплуатации

Страница: 4 / 12

7
Instructions
6
Instructions
Driver Installation
The software installation starts
with activating the reading func-
tion of the drive (CD-ROM).
If you are using the Optiarc Writer
with Windows 95/98/ME/NT/
200x/XP/Vista or IBM OS/2 Warp,
all necessary drivers will be
loaded automatically by the
operating system.
Drivers mentioned above are part
of the Operating Systems and not
available from NEC.
To use the IDE/ATAPI Optiarc
Writer with MS-DOS and MS-
Windows 3.x, you have to install
the attached driver software
before you can use the Optiarc
Writer for the first time.
Refer to the README.TXT file on
the driver disk for information
about installing this driver.
This drive* supports RPC according
to SFF8090v4 (RPC-2). The final
setting/definition of the video
region code is determined by the
fifth DVD video region code change.
For Windows 3.xx don’t use the
32 bit hard disk access, because
this mode is not supported for
DVD drives.
If the reading function is availa-
ble the next is to achieve the
writing function provided by the
writing software. Please insert
Your writing software CD-ROM
into the Optiarc Writer and use
the information provided with
the software (if the installation
does not starting automatically
you have to activate the
installation software manually).
To disable or enable drive’s buffer
under run prevention technology
you need a writer S/W supporting
this function.
Support
For local support like hotline,
service or drivers see the file
„ README.TXT “ on the software
CD-ROM or NEC´s Internet site
at http://www.neceurope.com
*) not for NR-9500
8 . Replace the mounting clips,
keeper bracket, and computer
cover. Refer to the Guide to
Operations that came with the
computer for help with this step.
Vertical use
The Optiarc Writer can be used in
the vertical position. When using
the Optiarc Writer, in the vertical
position, load and unload discs as
shown on the diagram below.
Only 12 cm discs can be used
when the Optiarc Writer is installed
vertically. Do not place 8cm discs
in the tray when using the Optiarc
Writer installed in this way.
Emergency Eject
The procedure described below
can be used to open the tray of
the Optiarc Writer if the EJECT
button is disabled by software or a
power failure occurs.
1 . Turn off the power to the
Optiarc Writer.
2 . If a disc inside still spinning
wait until spin stoped certainly.
3 . Insert a steel rod (about 1.3 mm
in diameter) into the emergency
eject hole and push firmly until
the cartridge is ejected. A stiff
paper clip may be used as steel
rod.
65 mm
(min. 45 mm)
Instructions