FF 30 - FF 100
Wall mounted, balanced flue, fanned gas boiler
User Instructions
Manufactured exclusively for Plumb Center by Ideal Boilers
Optia
200777-3.pmd
6/23/2005, 10:09 AM
1
Страница 1: ...FF 30 FF 100 Wall mounted balanced flue fanned gas boiler User Instructions Manufactured exclusively for Plumb Center by Ideal Boilers Optia ...
Страница 2: ...unning of the boiler Above the boiler 100 mm 4 At each side of the boiler 5 mm 1 4 Underneath the boiler 100 mm 4 In front of the boiler 75 mm 3 To light the boiler Refer to Frame 1 If a programmer is fitted refer to separate instructions for the programmer before continuing 1 CHECK THAT THE ELECTRICITY SUPPLY TO THE BOILER IS OFF 2 Open the controls access door by hinging downwards 3 Ensure that ...
Страница 3: ...a CORGI registered installer or in IE a competent person Loss of system water pressure Boilers fitted with Optia Sealed System Units only If the red arrow on the unit pressure gauge is set above zero and the system pressure is seen to fall below this value over a period of time then a water leak is indicated In this event a CORGI registered installer or in IE a competent person should be consulted...
Страница 4: ... the room thermostat by turning this fully up if this does not respond contact your installer Boiler is operating satisfactorily for central heating but will not operate for domestic hot water If an external programmer is fitted check that the domestic hot water channel is at an on period Check that the domestic hot water cylinder thermostat is set at the required temperature Test the cylinder the...
