4
12
Glue the three cardboard discs (3b, 3d and 3f) on top of each other as
shown, so that the holes are exactly aligned.
13
Cut four pieces of equal length (46 mm) from a round rod (4) and
clean up the saw cuts. Flatten the ends of the rods with pliers before
inserting them between the discs.Then, offset by 90°, glue them flush
to the intermediate disc.
3b
4
14
Glue the discs with the rods in the cardboard part (3a) in the recesses
provided.
3a
15
Glue the two cork discs (D+E) centered on the wheel from both sides.
16
Cut a piece (75 mm) from a round rod (4). Clean the saw cuts and then
glue it in the hole of the cork disc (E).
17
Glue 2 metal eyelets (5) to the cork part (F). Then glue the cork disc (G)
centered from below. Push the finished bracket onto the rod as shown.
To fix the turbine axle, glue a strip of paper approx. 5 mm wide and
60-80 mm long around the end of the axle.
F
G
5
5
Instructions 100.803
Wind Machine
3b
3d
3f
D
E
E
