Opitec OPI-Robo R3O3, Руководство пользователя

Страница: 3 / 9

3
E111666#2
INSTRUCTIONS
6. Glue the arms ( Dia 4) under the opening in the legs. Glue the legs with the countersink underneath, and leave to dry well.
Glue the second part in a mirror image to the first. Fix the feet from underneath with screws (9)
Arm
Leg
Foot
13
12
12
10
Dia. 4
7. Mark 20mm on each side of the motor axle (3) with a waterproof pen (Dia 5). Place the axle in a vice and saw off to the
previous mark. Clean up the saw cut with a file to remove any burr (Dia.6 ) Do the same with the other side
Dia.5
Dia. 6
Insert a machine screw (10) in the top opening in the legs and fix with a stop
nut (12) so that the can move smoothly in the opening!
Slide on the machine screws (10) a gear
on each side (15) between two washers
(13). Mount the legs on the machine
screws (10) and add a stop nut (12)
At the same time insert the machine
screw (10) in the side hole in the body
(The machine screw will make its own
thread!)
Note:
The countersink holes
face downward!
Note:
After addding the legs turn the gears. By turning the two gears they should be set at 180 degrees. ( One drive screw up
and the other facing down ) By turning the gears equally you can test the mechanical function. The legs should move
smaoothly and not catch on each other. Should they rub or catch, test the function once more.
Dia. 7
Dia. 8
Dia. 9
Make a notch at 8mm on the
axle so that the gear will be
held tight (s. Dia.7)
Glue a reducer (16) in both
of the gears (14) with instant
glue.(Dia. 8)
Squeeze some glue in the
reducer and gear so that it re-
mains tight on the axle. (Dia.9)