3
E101706#1
9) Remove part (L L) and sand the edges
Now take the corrugated card part from
step 1
Bend it around as shown (Grooves on the
inside)
And glue it to part (L L)
10) Remove parts (N/M/O) and sand
Glue parts (N+M) together as the pilot
seat
Then glue the pilot (O) in the middle of the
seat
11) Once dry glue the pilot+ seat into the fuse-
lage behind the windscreen
12) Add and glue the cabin from step 9 and
glue to part (C)
Glue the tailplane and fin to the rear of the
fuselage
6) Press out part (5) from the corrugated card
and cut off 10 x 40mm.
Smooth the raised side of the card with a
pencil or a ruler.
7) Cut out the tail fin (J+K) and clean up the
edges with sandpaper
Join the two halves of the fin together with
the corrugated card offcut leaving a 1 mm
gap between the two pieces
8) Remove the tailplane part (L) from the
sheet, sand the edges
Place the fin (J/K) in the middle of the tail-
plane so that the part of the rudder (J) pro-
trudes free at the back
5) Close the front of the fuselage with parts
(H) and (I)
7
5
6
9
11
10
8
12
1 mm
