Opitec 110.693, Инструкция по эксплуатации

Страница: 4 / 15

4
D110693#1
25
25
50
150°
150°
7
12
17
27
70
100
5
Ø 5
Ø 3
Ø 4 R5
R0,
5
Ø 5
4
Assembling the solar trike
INSTRUCTIONS
Step 7:
Cut the welding rod (4) handlebars to 100mm
Bend to shape as shown. See the pattern on
page 7
Step 6:
Mark 30mm with a pencil on the aluminium
on the U section (2).
Carefully saw the section as shown in the dra-
wing as shown so that the left side
is left . File any sawn edges smooth.
Constructing the front axle and steering
8. Mount the fork on the base frame
using to machine screws (19) from the
top.
Insert the steering from the side and
clamp it in position.
Add the aluminium part (f) under-
neath and fix with two stop nuts (23)
9. Set the battery holder (13) dia.9 in the
basic frame so that the red cable faces
the fork and the black faces the rear of
the trike . Line up the holes and rivet
the holder in place.
10. Fix the motor holder (e) to the back
of the gearbox using a machine
screw (20) and nut (23) Drill the
second hole 3mm dia. and insert a
screw (20) and nut (23).
Dia. 8
Dia. 9
Dia. 10
vor dem Bohren die Mitte markieren!!
Mark out with a pencil the holes in the top. Use sellotape to hold the
fork on the
Frame. Drill the first 3mm hole and then insert a machine screw (19)
and nut (23)
Then drill the remaining holes. Remove the sellotape and remove any
burr from the holes
Note 1:
Before cabling the solar trike cut the cables to length according to the plan. Remove about 10mm insulation from the
ends and twist wire strand together. Tin all the ends with solder and then trim the ends to 8mm long.
Flat side of rivet on top
To fix the battery holder
3mm hole
Drill through
Note 2:
Before connecting the voltage block tin the connections The solder on the black and red cables as shown.
Note 3:
On the plan shown ( See page 7 the points are shown with ( 0 ) where the shrink cover must be added before making the
cable connection
a
f