LOW TRACKING FUNCTION
When CONTROL and PITCH MOD are pressed at same time the LOW TRACKING FUNCTION is turned on or off. In LOW
TRACKING mode the pedal will only track lowest notes on fretboard leaving highest ones to pass through unaffected.
Pay attention that primary functions of CONTROL and PITCH MOD will be turned ON too, so you may need to press
CONTROL and PITCH MOD again to go back at previous status.
V-Zero memorizes the status of LOW TRACKING FUNCTION and will recall it at next power on. By default it’s turned
off.
LPF frequency modulation from OSC2
When CONTROL and LPF MOD are pressed at same time the Low Pass Filter is frequency modulated by a pitched
down version of OSC2. Basically this replaces LFO modulation (when LPF mod is short pressed). Modulation wave is
fixed as TRIANGLE but the pitch range can be selected with OSC2 Octave rotary switch. Modulation is proportional to
the note played (the lower the note pitch and lower frequency modulation will be).
Pay attention that primary functions of CONTROL and LPF MOD will be turned ON too, so you may need to press
CONTROL and PITCH MOD again to go back at previous status.
V-Zero memorizes the status of LPF frequency modulation and will recall it at next power on. By default it’s turned
off.
LFO groups
When CONTROL and LFO Wave are pressed at same time the LFO selection switches between Sine/Square and
Square/Sawtooth. This simply means that by pushing LFO wave button it will either switch between Sine (LED off) /
Square (LED on) or Square (LED off) / Sawtooth (LED on).
Pay attention that primary functions of CONTROL and LFO WAVE will be turned ON too, so you may need to press
CONTROL and LFO WAVE again to go back at previous status.
V-Zero memorizes the status of LFO groups and will recall it at next power on. By default Sine/Square group is
selected.
HOW to set GATE ON threshold and TRACKING range:
Long press CONTROL footswitch for 5 seconds until CONTROL LED starts blinking. Move LFO RATE pot to set GATE ON
threshold and LFO DEPTH pot to set TRACKING range. Play until you find the best setting to suit your playing. Once
finished press CONTROL once to store the settings and exit.
You can set both GATE and TRACKING at same time or just one of them. Parameters for GATE ON and TRACKING are
only updated when pots are moved, so if you only want to set GATE ON only move LFO RATE pot and leave LFO
DEPTH in position.
GATE ON threshold sets the point where gate turns on and signal from oscillators is output.
