Opera Nivel Pro, Руководство по эксплуатации

Страница: 11 / 28

8
4 Operation
4.1 Appropriate cookware Induction hotplate will function perfectly only if appropriate pot is used.
‡ The pot should be in the middle of the hotplate during cooking.
‡ The appropriate pot is the one which enables induction, for example steel, enamel
or steel alloy. Pots made from steel alloy with copper or aluminium bottom, or
glass pots are inappropriate.
‡ If you use the pressure pot, keep it under close surveillance until proper pressure
is obtained. Hotplate should first operate on maximum power, then follow the
manufacturer’s instructions.
When buying cookware, check if it bears the label “allows induction”.
COOKING ZONES Ø MIN. PAN BOTTOM
Ø 110 mm
Round
(SINGLE)
Ø 110 mm
Note:
When Bridge function is selected, you can use the created zone in different ways,
with one or two pots. If you use larger pots than the recommended maximum size,
the heating time will be longer, because the heating will propagate from center to
edges of the pot by conduction, in this case also the temperature will be very
inhomogeneous.
Magnet test
Use small magnet
A
to test if the dish bottom is magnetic. Only dishes where
magnet sticks to the bottom are suitable.
Dish recognition
One of great advantages of the induction hotplate is dish recognition.
When the hotplate is on, the power indicator displays . If you place the dish over
that hotplate within the following 10 minutes, the hotplate recognizes the dish and
turns on to the pre-set power value.
At the moment you remove the dish from the hotplate, power is suspended. If you
place smaller dish upon the hotplate and it is recognized, the hotplate will only use
the amount of energy required to heat the dish according to its size.
Hotplate may be damaged if:
x
empty hop are heated up.
x
you don’t use the appropriate pots.
x
you use clay dishes which leave scratches on the glass surface.
x
you don’t wipe the pot bottom.
The use of bad quality cookware or any adapter for non-magnetic cookware
invalidates product warranty. In this case, the manufacturer cannot be held
responsible for any damage caused to the appliance and / or objects closed to the
same.
TABLE OF CONTENTS EN
Octa
(SINGLE)