8
4. To set tracking force, two counterweights(Part 2) are supplied to enable correct tracking force to
be applied to cartridges of various weights. The general tracking force can be obtained by moving
the counterweight towards or away from the pivot point on the shaft. The final exact tracking force
can be done by stylus gauge after cartridge installation.
5. Put the anti-skate weight (Part 3) down on the support wand of anti-skate and secure it to one of
the three locations (select a best location according to the tracking force of your cartridge)
Note:
The anti-skating force is adjusted according to the mass of the cartridge as follows:
T8
’s down force: 10-14mN, 15-19mN, 20-35mN (Groove 1st, 2st, 3st from the pivot point of tone
arm).
When tightening the counter-weight, insure that the weight is perfectly vertical otherwise this may
affect your cartridges azimuth settings.
