User Manual
D.
Power Feeding Input
If one of the four power feeding connectors is CONNECT(ON), user should
connect a D-type connecter from pc power supply to this jack, the D-type
connecter is used to provide power to your CDROM ahd 3.5”HDD.
E.
Power Supply Selection
Some newest model PCs do not p5V on the PCI slots, at those
cases, use has to set the jumper to 3.3v.
F.
PCM IN/PCM OUT
These are for future usages.
2)
Power off PC, remembering unplug the AC power cable
3)
Insert B400P into a 3.3v or 5.0v PCI slot
4)
Plug the hard disk power supply cable( D style) to power feeding input jack
if need providing power to external equipment, please refer jumper setting
section for the detail
5)
Plug back the AC power cable, and power on PC
2.
Software Installation and Setup
B400P
supports
original
mISDN
driver
form
http://www.misdn.org/index.php/Installing_mISDN. Customers can download it
from
that URL
. There are few steps to install the driver drivers.
1) Checking the B400P hardware by command: lspci -vvvvvvvvv
2)
Checking the supporting packages
Note that if there is no kernel source in the system, user should install
them. User can run yum again:
yum install kernel-devel
`. If user uses this
command yum will install the sources for your current version of the kernel.
It is time to check for the availability of some other packages:
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
