Opengear MFC-8322-S, Руководство пользователя, Страница: 17 / 72

MFC-8322-S and MFC-OG3-N User Manual (Iss. 01) Installation • 2–3
Installing a Network Controller Card
This section outlines how to install an Network Controller Card in an openGear frame. The same
procedure applies regardless of the frame or card type. The Network Controller Card installs in
the last slot on the right side of the openGear frame (when facing the frame).
To install a Network Controller Card
1. Power off the openGear frame.
2. Open the frame door.
3. If necessary, remove any cards from the frame that would interfere with easy access and
lines of sight.
4. Lift the lock before inserting the card into its slot. ( Figure 2.1 )
Figure 2.1 MFC-OG3 Series Card — Lock
5. Insert the Network Controller Card, with the component side out into the card guides
between the dividing wall and the last slot, ensuring the card does not touch the Card
Retaining Screw.
6. Slide the card in the slot until firmly seated.
7. Ensure the lock on the front edge of the card is engaged in the down position.
8. Power up the frame.
9. Close the frame door.
10. Check the operation of the fans. If the fans do not operate, verify that:
• the Network Controller Card is seated properly in the frame backplane.
• the Network Controller Card is aligned to the Fan PCB when the door is closed.
Caution
— You must install the MFC-8322-S and the MFC-OG3-N into an OG3-FR
series frame. Attempting to install these cards in another frame type can damage your
card.
Lift to unlock