Opengear ADA-8402-A, Руководство пользователя

Страница: 17 / 36

ADA-8402-A User Manual (Iss. 01) Installation • 2–3
Installing the ADA-8402-A
This section outlines how to install a rear module and card in a DFR-8300 series frame. The same
procedure applies regardless of the frame or card type. However, the specific rear module you
need to install depends on the frame you are using.
Rear Modules for the ADA-8402-A
The Rear Module for the ADA-8402-A depends on the openGear frame you are installing the
card into.
• DFR-8310 series frame — When installing the ADA-8402-A in the DFR-8310 series
frames, the 8310AR-030 Rear Module (R1A-8402) is required.
• DFR-8321 series frame — When installing the ADA-8402-A in the DFR-8321 series
frames, the 8320AR-030 Full Rear Module (R2A-8402), or the 8320AR-031 Split Rear
Module (R2SA-8402) can be used. When using a Full Rear Module in the DFR-8321, use
the even numbered slots, such as 2 or 4, to ensure that the card aligns with the rear
module.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “ Installing the ADA-8402-A ” on
page 2-4.
Use the following procedure to install a Rear Module in your DFR-8300 series frame:
1.
Locate the card frame slots on the rear of the frame.
2.
Remove the Blank Plate from the slot you have chosen for the ADA-8402-A installation.
3.
Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. ( Figure 2.1 )
Figure 2.1 Rear Module Installation in a DFR-8300 Series Frame (ADA-8402-A not shown)
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
Screw Hole
Module Seating Slot