STAGE 1
Pre-installation
Turn off water supply to cistern and remove cistern lid.
While still full, mark the normal water level on the inside of the cistern.
Flush the cistern and remove all remaining water with a sponge or cloth.
Disconnect flush pipe.
Remove old siphon and existing handle or button.
Note:
Ensure the top of the new variflush valve is below the lowest overflow point of the cistern
including all apertures.
STAGE 2
Fitting your Torbeck
®
Variflush
®
valve
1
2
3
4
5
Turn off
water supply
and remove lid
Disconnect
flush pipe
Remove old
siphon and
handle
Mark
water
level
Flush and
remove all
remaining
water
1
2
3
4
4
5
Twist bayonet
connection
clockwise to
separate
Hand tighten
universal nut
as shown
Push
button
spindle
Cable
end
assembly
Do not
kink cable
Threaded
outlet
Sealing
washer
1
5
2
Taking the variflush drop valve in
both hands, twist clockwise and
separate.
Fit the base of the valve into
the cistern. It is essential that
the black sealing washer is
inside the cistern to achieve a
water tight seal. When fitting
to a close-coupled cistern it
may be necessary to reduce the
length of the threaded outlet
by 10mm using a hacksaw prior
to installation. Nut should be
tightened using spanner provided.
Re-assemble the variflush valve.
By matching bayonet fitting and
rotating anti-clockwise (reverse 1
above). Ensure float remains free
to operate.
Twist overflow anti-clockwise
and adjust height to 25mm above
waterline. Twist clockwise to lock
into place.
Fit the flush button in the
cistern, snap cable end assembly
onto push button spindle. The
cable must be free to operate,
lifting the overflow tube when
depressed.
Refit flush pipe
Turn on water supply.
6
7
1
2
3
4
5
CISTERN
Adjust height, then
twist back to lock
into position.
25mm
Twist
** See reverse for exceptions
