Opalum® FLOW series
Opalum® STREAM series
Remote control pairing guide
w w w . o p a l u m . c o m
The Opalum FLOW and STREAM series systems uses radio frequency (RF) remote controls. To not
interfere with other Opalum systems or similar RF equipment each control hub and remote control
is manufactured and sold as a unique pair. However, if the remote control or control hub is
replaced it is easy to re-pair the new couple to enable communication.
Step 1:
Disconnect the power supply from the control hub
and
from the wall socket.
Step 2:
Open up the remote control using the provided remote control opener pin (or a similar
thin sturdy object). Insert pin in the hole on the back of the remote control marked
“Push here to open”
. Push firmly inwards until front panel and housing is separated.
Step 3:
Remove both batteries from the battery holder.
Step 4:
Next to the battery holder is a three pin connector with a jumper installed over two of
the pins. Figure 3 shows the normal operating position of the jumper.
Remote control pairing guide v1.01
1/2
Fig 3: Jumper in normal operating position
Fig 1: Remote
control opener
pin
Fig 2: Push to open
the remote control
Pus
h h
ere
to o
pen
->
Jumper in NORMAL mode
