Opal CIC972, Руководство пользователя

Страница: 4 / 12

6 7
11
11
10
1
2
3
4
5
6
7
8
9
GB
ASSEMBLY INSTRUCTIONS FOR BATHROOM
FURNITURE
The recommended heights for hanging the
cabinets are shown in the illustration 1 (page 3).
NOTE: Take care during installation and
assembly. Any strong mechanical influence
could damage the painted or laminated
surfaces, mirrors and electrical parts. Place the
item on a soft, clean surface during installation.
Use only the original fittings supplied with the
item for
installation. The item could later be damaged or
broken if fittings other than the original fittings
are used.
ASSEMBLY OF SUSPENDED CABINETS
Furniture should be installed onto structures
and materials that can withstand the weight
of the item and the stress caused by the use.
Choose fasteners appropriate for the walling
material (not necessarily included). Before
using the item, adjust the hinges and slide rails
and check the tightness of screws and joints.
Make sure that the item is not going to tip over,
fall or detach from the fastenings.
Electrical installations may only be
carried out by qualified electricians.
LED LIGHTING
The electrical part of the cabinets is complete
and fully prepared for connection to a standard
electrical system (~220V-50Hz). The LED
spotlights are fed through a transformer located
in the electrical box in the cabinet.
The electrical parts will connect to a standard
electrical system of ~220V-50Hz.
Attention: Never feed low-voltage LED
spotlights directly from the 220-240V mains.
Always use a LED transformer (220-240V/12V).
Use only LED bulbs (12V-2.0W, IP44 safety).
The space between the LED spotlights and any
combustible material should be at least 30 cm.
For detailed instructions, refer to the assembly
instructions for electrical parts. Always switch
off the
electricity before installation and during the
cleaning process. Mirrored cabinets with
lighting should be installed by an authorised
professional only. Electrical installations must
comply with local regulations.
Technical parameters of LED spotlights:
IP44 LED SPOT LIGHT
Power: 3.2W
Voltage: 12V
Lightoutput (lm): 175 lm, 4200 kelvins
IP44
ASSEMBLY AND ADJUSTMENT OF HINGES
Door hinges are mounted with screws. The
direction of opening the doors is chosen by
the client. The position of the doors should be
adjusted as shown.
HOW TO TAKE CARE OF YOUR BATHROOM
CABINET
Conditions of use: The bathroom furniture
should be mounted in heated and ventilated
rooms (with a temperature of +5 to +35°C and
relative humidity of 30-75%). Do not place the
bathroom furniture against heating equipment.
Ensure that the bathroom furniture is not
exposed to:
• The direct influence of steam on its surfaces;
• Mechanical influence (avoid striking or
scratching surfaces with sharp objects); and
• Liquid influence (clean wet surfaces
immediately with a dry cloth).
Many concentrated cosmetic liquids, if spilled,
can damage the surfaces if not cleaned
immediately.
Everyday care: All of the materials used by our
company can be easily cleaned. Do not use
abrasive or solvent-based cleaning products.
Surfaces can be easily cleaned with soap and a
damp cloth. Damp surfaces should be
carefully cleaned with a clean, dry cloth. For
glass surfaces use only special, non-abrasive
cleaning products.
WARRANTY TERMS AND CONDITIONS
The warranty covers defects due to design, raw