3
A.
Remote control
B.
Switch button
C. Indicator cover
D. Base 1
E. Base 2
F. Attachment screws
REMINDING:
there are 2 corresponding holes at the base, the 2 pillars at the seat need to pass through these 2
holes when assembly the base onto the fans.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power cord is
damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person with similar
qualifications, in order to avoid any risk.
Operation
The fan can be operated by the control panel located on the top of the fan (B) or by remote controller(A)
1.
Plug the fan into the standard domestic socket.
2. Press the ON/OFF button , the fan will start running at LOW speed
3.
Press the SPEED button to select the desired level, Low, Medium, High, the indicator of speed level is lighted
at indicator cover(C).
4.
Press the MODE button to set the fan as Natural or Sleep mode, the mode is lighted on the indicator cover(C)
as NAT, SLE.
5.
Press the OSC button to allow the fan oscillate the wind direction, to stop the oscillation, press the OSC
button again, the maximum angle is 86 degree.
A
B
C
