13
12
a.
You won’t need the standing attachment if you’re
using adhesives. Release it from the back cover by
pressing the marked square and pulling the stand
away. The standing attachment will come free.
c.
If you haven’t already done
so, replace the magnetic back
cover. Peel off one side of
each of the included adhesive
pads and place them firmly
onto the areas shown below.
d.
Peel off the other backing
on the adhesive pad. Firmly
press the newly-exposed
adhesive onto the desired
surface for 30 seconds.
c.
Replace cover
d.
Press adhesive onto surface
Mount with Adhesive Pads (optional)
b.
Use a damp cloth to
clean the area where
you want your sensor to
be so that the adhesive
pads stick properly.
Press marked square
Pull sensor up and off the stand
