SERVICE NOTES
Visit www.ONYXmotorbikes.com for more information and good vibes.
3
SVC001_Recommended Maintenance Schedule_RCR and CTY_v01
BASIC CARE
–
THE BARE BONES BASICS
1.
Regularly clean and lubricate all moving parts, tighten nuts/bolts, and adjust as required. This includes all
steering, bicycle pedals, suspension, and wheel parts. See the RCR Hardware and Torque Specs Service
Notes document for hardware and tightening information for your ONYX Motorbike.
2.
Keep your bike clean by wiping the frame with a damp cloth. If needed, apply a mild cleaner or soap
mixture to the damp cloth and wipe the frame. Dry your bike by wiping with a clean, dry cloth. Never hose
down or submerge the bike or any components in water or liquid as the electrical system may be
damaged.
3.
Occasionally check wiring and connectors, especially up and around the handlebars, to ensure there is no
damage and that the connectors are secure. Also check the condition of any wire wrap and cable ties to
make sure that they are intact. Replace any that are loose, frayed, or partially cut.
4.
Properly maintain your battery by keeping it charged or charging before use. Please note that it is
possible and normal for the battery to lose some charge if it is left sitting for a few days, so it may be
necessary to top it off for as long as a couple of hours if you need the battery to have a full charge for your
intended ride.
If you know that you will not be riding for more than one week, keep the battery charged to more than a
50% level and keep the battery at room temperature. See the BATTERY CARE/MAINTENANCE/SAFETY
TIPS section of your RCR User Manual for more useful information about battery use and care.
5.
Whenever possible, store your ONYX Motorbike under shelter or cover it with a quality cover. Even using a
large barbecue cover can work well! Otherwise, avoid leaving the bike in the rain or exposed to corrosive
materials. If exposed to rain, dry your bike afterwards and apply anti-rust treatment to chain and other
unpainted steel surfaces.
6.
Riding on and near the beach in coastal areas or even in areas that may use road salt for ice and snow can
expose your bike to salt, which is very corrosive. If you ride in these areas, wipe down your bike frequently
and wipe or spray all unpainted parts with anti-rust treatment.
Please note that damage due to corrosion is NOT covered under warranty so special care should be given
to extend the life of your bike when used in coastal areas or areas with salty air or water.
7.
If the front hub, front fork, or swing arm bracket have been submerged in water or liquid, they should be
taken apart to be cleaned and greased with a quality grease. Even though the rear hub motor is protected
and sealed against dirt and water intrusion to an IP54 level, it should not be submerged in water. A splash
through a small creek or large puddle is normally fine, but it doesn’t mean that you should trudge across a
river. If you do plunge into excessive amounts of water with the rear hub motor, try to get it to a dry
environment as soon as possible, dry it off, and let it air dry as long as possible.
8.
If the paint has become scratched or chipped in the metal, use colored touch up paint or even clear nail
polish on the scratch to help prevent rust. If rust has already started, carefully clean the rust off with a
small wire brush or emery cloth, and coat the scratch with touch up paint.
