Onwa ARGO 300, Руководство по эксплуатации

Страница: 6 / 12

12. Power Selecto
High
LOW.
13. Mode switch
14.ANL + NB/Off Switch
15.Microphone jack
16. 13.8 V DC jack
17.Exermal Speaker jack
18. Antenna
Installation
r
Enables you to select the RF power output of the transceiver in 2 ways.
. In this position the transceiver produces full rated power for maximum
communication range.
In this position, the minimum R power output is obtained, may be used for
short range communication.
Selects the mode of reception and transmission -AM (amplitude modulation).
FM (frequency modulation)
In the upper position the ANL is activated lower position the ANL is off and in
together with the NB(noise blanker).
Accepts plug form the microphone supplied. The jack has a locating key inside and
allows the plug inserted in only one way. Do not force the plug but align key way
properly onto the jack.
13.8 V DC power for the transceiver supplied through this socket (using DC power
cable supplied).
Used to connect an external speaker (8 Ohm 4 W) as an extra sound source.
Insertion of the plug from a speaker will silence the internal speaker automatically.
Accepts a PL 259 type coaxial connector from the antenna lead-in cable.
Safety and convenience are the primary factors in deciding exactly where to locate
your transceiver. The transceiver is designed for ease in control accessibility .Be sure
that the unit is located so that it does not interfere with the driver or impair access to
any controls. Connecting cables must be routed and secured in such a controls.
Interference from either the operation of the brake, accelerator or other controls.
Interference from either the unit or connecting cables may contribute to the loss of
control of the vehicle.
The transceiver is designed for use with either negative or positive ground electrical
systems.
RF
F
6