IMPORTANT MAINTENANCE & CARE:
As with any rotating brush cleaning device,
Swivel Sweeper’s four cleaning brushes will
accumulate fine debris such as hair, thread and
other particles. To maintain optimal sweeper
performance, clean the sweeper’s rotating
brushes of hair and debris and its “Air Filter” of
dust and dirt as necessary following the
directions below.
Step 1)
Make sure the Swivel Sweeper is
turned OFF and remove the battery to
ensure unit does not accidentally turn on.
Step 2)
Turn Swivel Sweeper Max®
upside down to allow for easy access to
the removable brush heads.
Step 3)
Locate the brush head with
tangled debris. Remove the brush head by
pressing inward – in the direction of the arrow –
to release one side of the brush head from the
Sweeper base,
(SEE FIG. 5)
and then upward
and away from the sweeper
(SEE FIG. 6)
.
Step 4)
Remove the tangled debris by pulling it
away from the brush head or scraping with a
utensil (not provided)
(SEE FIG. 7)
.
CAUTION: Be careful when removing
debris. Do not use a utensil with a
sharp edge. Avoid using blades or
sharp tips when cleaning brushes.
Step 5)
Dispose of debris properly. Then
reconnect the brush head in reverse order of
removal
(SEE FIG. 8)
. Check that the brush is
returned to the original locked position
(SEE
FIG. 9)
. Note that the “dot” on the shaft will be in
the position away from the reference arrow.
TO ASSEMBLE SWIVEL SWEEPER:
A. Upper Pole
B. Middle Pole
C. Lower Pole
D. Sweeper Head
Step 1)
Screw “Pole A”
onto “Pole B” until
secure.
Step 2)
Screw “Pole B” onto
“Pole C” until secure.
Step 3)
Align the arrow on “Pole C” with the arrow
on “Sweeper Head D.” When arrows are
aligned, pole will easily slide onto Sweeper
Head. Then push firmly together until pole
locks into place.
CHARGING YOUR BATTERY:
Step 1)
Plug the “Battery Charger” into a
standard electrical outlet as below:
UL/cUL 120V ~ 60Hz
GS 220V - 240V ~ 50/60Hz
Step 2)
Align the arrow on the “Rechargeable
Battery” with the arrow on the “Battery Charger.”
Then, insert the “Rechargeable Battery” down
into
the “Battery Charger”
(SEE FIG. 1). NOTE:
Red
light on the front of the “Battery Charger” should
turn on to indicate that the battery is charging.
FIG. 9
FIG. 8
FIG. 7
FIG. 1
FIG. 6
FIG. 5
7
4
