HOBO® State Data Logger (UX90-001x) Manual
15430-A MAN-UX90-001
The HOBO State/Pulse/Event/Runtime data logger records state changes, electronic pulses and
mechanical or electrical contact closures from external sensing devices. Using HOBOware®, you
can easily configure the internal magnetic reed switch or the external sensor to monitor and
record data in a wide variety of applications, such as energy consumption, mechanical
equipment operation, and water and gas flow. This compact data logger also has a built-in LCD
screen to monitor logging status, battery use, and memory consumption. There are two models
of the HOBO state logger: the UX90-001 has 128 KB of memory while the UX90-001M has 512 KB.
Specifications
Internal Sensor
Maximum State, Event,
Runtime Frequency
1 Hz
Preferred Switch State
No magnet present (normally open)
External Input
External Contact Input
Electronic solid state switch closure or logic driven voltage output
Range
0 to 3 V DC (USB powered), 0 to 2.5 V DC (battery powered)
Maximum Pulse Frequency
50 Hz
Maximum State, Event,
Runtime Frequency
1 Hz
Pulse, Event Lockout Time
0 to 1 second in 100 ms steps
Solid State Switch Closure
Input Low: < 10 K
Ω
; Input High: > 500 K
Ω
Internal Weak Pull-Up
100 K
Ω
Input Impedance
Solid state switch closure: 100 K
Ω
pull up
Logger
Resolution
Pulse: 1 pulse, Runtime: 1 second, State and Event: 1 State or Event
Logging Rate
1 second to 18 hours, 12 minutes, 15 seconds
Time Accuracy
±1 minute per month at 25°C (77°F) (see Plot A)
Battery Life
1 year, typical with logging intervals greater than 1 minute and
normally open contacts
Memory
UX90-001: 128 KB (84,650 measurements, maximum)
UX90-001M: 512 KB (346,795 measurements, maximum)
Download Type
USB 2.0 interface
Download Time
10 seconds for 128 KB; 30 seconds for 512 KB
Logger Operating Range
Logging: -20° to 70°C (-4° to 158°F); 0 to 95% RH (non-condensing)
Launch/Readout: 0° to 50°C (32° to 122°F) per USB specification
LCD
LCD is visible from: 0° to 50°C (32° to 122°F); the LCD may react slowly
or go blank in temperatures outside this range
Size
3.66 x 5.94 x 1.52 cm (1.44 x 2.34 x 0.6 in.)
Weight
23 g (0.81 oz)
Environmental Rating
IP50
The CE Marking identifies this product as complying with all relevant
directives in the European Union (EU).
HOBO State Data Logger
Models: UX90-001
UX90-001M
Included Items:
•
2.5 mm input cable
•
Command™ strip
•
Double-sided tape
•
Hook & loop strap
•
Magnet with 2 screws
Required Items:
•
HOBOware 3.3 or later
•
USB cable (included with
software)
Accessories:
•
Wattnode kWh transducers
•
Power & Energy Meter
(T-VER-E50B2)
•
Water Flow Meter Sensor
(T-MINOL-130)
•
U-Shuttle (U-DT-1)
Additional sensors and
accessories available at
www.onsetcomp.com.
