Protective Case
Page 3 of 6
6.
Slide the dome nut onto the end of the sensor cable. The threaded side of the dome nut should be
facing towards the connector. Then, slide the cable through the PG-16 body and through the hole
in the case. Push the cable into the slit insert and position it as shown.
7.
Plug the sensor into the logger and place the logger back in the case if you removed it. Adjust the
cable length as necessary so there isn’t excess cable inside the case.
8.
Push the slit insert back into the PG-16 body. Pushing the slit insert in at a slight angle and with a
slight twist may help it slide in more smoothly.
9.
Screw the dome nut onto the PG-16 body, tighten by hand, and then an additional ½ to ¾ turn
with an adjustable wrench. The dome nut must be very snug.
10.
If you are using a remote alarm or auto-dialer with the logger: Remove the dome nut from the
alarm port at the bottom of the case. Slide the dome nut onto the alarm relay cable and then insert
the cable through the alarm port. Attach alarm cable to the logger as described in the
HOBO LCD
Data Logger User’s Manual
(you’ll need to remove the logger from the case and reposition it
when finished configuring the alarm relay cable). Screw the dome nut back on, tighten by hand,
and then an additional ½ to ¾ turn with an adjustable wrench.
11.
Place the desiccant pack in the case to minimize internal condensation.
Dome nut
Slit insert
Sensor cable and
connector
PG-16 body in sensor port
Alarm port with
dome nut
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
