© 2009 Onset Computer Corporation
Part #: MAN-CASE-4X
Doc #: 7188-B
Protective Case (Part # CASE-4X)
for HOBO
®
U14-002 LCD Temp/RH Data Logger
The Protective Case allows you to mount the HOBO U14-002 LCD
Temp/RH data logger in wet, dusty, or condensing environments.
The Protective Case is tested to NEMA 4X (IP65) Standards for
protection from corrosion, wind-blown dust and rain, splashing
water, and hose-directed water. A removable watertight fitting with
an O-ring seal allows you to easily download data from the logger
using a laptop or HOBO U-Shuttle (U-DT-1).
Assembly Instructions
The Protective Case is shipped fully assembled. This section explains
how to install the HOBO LCD Temp/RH logger in the case,
including the tools required for assembly.
Items required
To complete the assembly instructions, you will need the following items:
•
Protective case, hook and loop tape, and desiccant pack (included in this package)
•
HOBO LCD Temp/RH logger (Part # U14-002)
•
External temperature or temperature/RH sensor (Part # S-THB-M00X or S-TMB-M0XX)
•
Phillips-head screwdriver
•
Pen, pencil, or other blunt instrument
•
Adjustable 8 inch or 10 inch crescent wrench
•
Utility or pocket knife
•
Alarm relay cable (if you will be using the logger with a Remote Alarm (ARA) or
Automatic Dialer (AVD-45)
Steps
1.
Using a Phillips-head screwdriver, remove the four screws and clear cover from the case.
2.
Peel the backing from one half of the hook and loop tape, and attach the tape on the back of the
HOBO LCD Temp/RH logger just above the battery door.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
