January 16, 2020_V1
January 16, 2020_V1
Remote
1.
Power:
Press to power the unit on or
off.
2.
CD:
Press to switch to CD Mode.
3.
Mute:
Press to mute volume.
4.
FM:
Press to switch to FM Radio Mode.
5.
Bluetooth:
Press to switch to
Bluetooth Mode.
6.
Aux/Line In:
Press to switch to a
connected audio system or device.
7.
Play/Pause/Pair:
Press to play or
pause audio (CD/BLUETOOTH
MODES).
Press and hold to begin pairing to a
Bluetooth device.
8.
Skip/Tune:
Press to skip audio tracks
(CD/BLUETOOTH MODES).
Press and hold to scan FM radio
frequencies (FM MODE).
Press to fine tune the frequency
adjustment (FM MODE).
9.
Stop:
Press to stop audio playback
(CD/BLUETOOTH MODES).
10.
Prog:
Press to begin programming
a CD.
11.
Repeat:
Press to change playback
modes from Standard play, Repeat,
or Shuffle.
12.
Bass:
Press to adjust bass level
13.
Volume:
Press to adjust the volume
level up or down.
1
8
8
8
8
8
8
8
8
8
4
5
Remote Battery
Requires 1 CR2025 button cell battery (included). Follow
the figure on the back of the remote to replace the
battery.
Open the Disc door
Close the Disc door
FM Radio
1. Adjust the position of the FM wire antenna to adjust radio reception.
2. Press the
Power
button to turn the unit on.
3. Press the
Source
button to switch to
FM Radio Mode.
4. Press and hold the
Skip/Tune
buttons to scan FM frequencies. Press the
Skip/Tune
buttons to fine
tune the frequency adjustment.
Programming Radio Stations
1. With the speaker on and in
FM Mode
, press and hold the
Program/Prog
button on the unit or the
remote. The display will start blinking a preset number (Ex: P01).
2. Use the
Skip/Tune
buttons to select a preset number you wish to save, then press the
Program/
Prog
button again to save the frequency to that preset number. Up to 20 stations may be preset.
3. To select different presets, press the
Program/Prog
button, then use the
Skip/Tune
buttons to
select a preset.
Programming a CD
1. While playing a CD, press the
Stop
button.
2. Press the
Program/Prog
button on the unit or the remote.
3. Press the
Skip/Search
buttons to select a track from the loaded CD to play first.
4. Press the
Program/Prog
button again.
5. Repeat steps 3 and 4 to program tracks from the loaded CD to play in the order they are selected.
6. Press the
Play/Pause
button to begin playing the programmed CD.
7. Press the
Stop
button twice to cancel the program.
CD & Radio
Loading & Playing a CD
Note: This unit is not compatible with MP3 CDs.
1. Press the
Source
button to switch to
CD Mode
2. Slide
Open
button right to open the Disc door.
3. Load a CD or CD-R/RW disc into the unit with the label side facing you.
4. Push the Disc door down until the Disc door is locked.
5. Press the
Play/Pause
button to begin playing the loaded CD. Press the
Skip
buttons to cycle
through different tracks. Press and hold the
Skip
buttons to search through an audio track.
1
4
5
8
9
11
13
12
10
7
6
3
8
2
