ONLINE ELECTRONICS LTD
600_5001_A01
Page 11 of 12
entering the low powered “sleep mode”. The unit will remain in the low power mode until the
delay time has elapsed.
This initial behavior allows the user to confirm that the unit has been activated, is pulsing at
the correct pulse rate (which also verifies the DR/GRID connection) and that the delayed start
time for the operation is correct.
5.
MAINTENANCE
Familiarise yourself with all of the rules for the safe operation of this equipment as described in
Section 3 RULES FOR SAFE OPERATION.
5.1.
O-RING REPLACEMENT
1.
Fully remove the BATTERY ENDCAP and any batteries. NOTE: The TRANSDUCER
ENDCAP should not be removed.
2.
Remove all O-rings and clean the sealing surfaces.
3.
Examine all surfaces for signs of corrosion, scoring or other damage. If there is
excessive damage, the mechanical parts may need to be replaced.
4.
Lightly grease all sealing surfaces and each O-ring using a suitable grease (e.g. DOW
CORNING MOLYKOTE 111 COMPOUND).
5.
Lightly grease each O-ring with a suitable grease (e.g. DOW CORNING MOLYKOTE 111
COMPOUND).
6.
Referring to Section 4.4 BATTERY REPLACEMENT re-insert the batteries and then refit
the BATTERY ENDCAP to the battery end of the housing.
5.2.
ROUTINE MAINTENANCE AND STORAGE
All Online Electronics Ltd products are designed to require minimum maintenance. The housing
should be cleaned using fresh water and cleaning agents as necessary. Do not use chemicals
which could be damaging to the housing, the PU transducer, the nitrile rubber O-rings, or any
connectors.
Online Electronics Ltd can supply redress kits containing a complete set of replacement
batteries, O-rings and O-ring grease, contact Online Electronics Ltd for guidance.
If the unit is to be placed in storage for a long period of time ensure the unit has been cleaned
and batteries removed.
6.
WARRANTY
Online products are guaranteed for one year from the date of purchase. Goods should be
returned; transportation prepaid, to Online Electronics Limited.
There is no charge for parts or labour should any product require repair due to a
manufacturing deficiency during the guarantee period.
In the event of a manufacturing deficiency the inward transportation costs will be repaid to the
client.
