ONLINE ELECTRONICS LTD
3015_5001_A01
Page 9 of 17
4.3.
FUNCTION TEST
An OEL EM receiver system is required to receive the signal from a 3015X transmitter. Refer to
the relevant EM receiver manual for instruction on setup and operation of the EM receiver
system.
1.
Place the EM receiver antenna approximately 10m away and parallel to the transmitter.
2.
Activate the transmitter as detailed in Section 4.1 TURNING ON.
3.
Confirm that a clear signal is received.
4.
Switch the transmitter between OFF, RATE 1 and RATE 2 several times to ensure that the
signal received reacts as expected. Refer to Section 4.5 MODE SELECT for further
information on changing transmission rates.
5.
An inherent null spot is detectable when the antenna is at 90 degrees to and pointing at
the centre of the transmitter allowing accurate positioning of a pig. Refer to the relevant
EM receiver manual for further information.
6.
Turn OFF the transmitter as detailed in Section 4.2 TURNING OFF.
7.
If all results were as expected then the system is functional.
4.4.
DEPLOYMENT
Before each deployment ensure that the following checks have been completed.
1.
Ensure that the transmitter has been installed as detailed in Section 4.6 INSTALLATION.
2.
Visually inspect all system components to ensure that they are secure and undamaged.
3.
Refer to the Page 2 of this manual for the expected battery lifetime and ensure that it is
adequate for the planned operations.
4.
Activate the transmitter as detailed in Section 4.1 TURNING ON.
5.
Complete a 4.3 FUNCTION TEST.
