Onkyo TX-SV353, Инструкция по эксплуатации

Страница: 5 / 28

5
Before operating this unit
1. Determine the proper voltage for your
area: 220-230 V or 120 V.
2. If the setting on the voltage selector is
not correct, insert a screwdriver into the
groove in the switch and slide the
switch completely to the right (120 V)
or the left (220-230 V), whichever is
appropriate.
The worldwide model is equipped with a
switch that controls the AM (9
kHz/
10 kHz) band tuning steps.
Please set this switch to match the tuning
step frequency in your area.
U.S. & Canada: 10 kHz
Other areas: 9 kHz
The following information will help you
get optimal use from the remote controller.
●
Place this unit away from direct bright
light which can prevent proper opera-
tion of the remote controller.
●
Make sure audio rack doors do not have
tinted glass. Placing this unit behind
such a door may prevent proper remote
controller operation.
Remove the battery compartment cover by
opening it as shown in the illustration.
Load two AA (R6 or UM-3)-size batteries
into the remote controller with the plus (+)
and minus (–) terminals positioned as indi-
cated by the diagram inside the battery
compartment, then close the cover.
●
Remove empty batteries immediately to
avoid corrosion damage.
●
To avoid potential corrosion damage,
never mix old batteries with new ones.
●
The manganese batteries supplied with
this unit have a service life of approxi-
mately six months, depending on the
frequency of use.
●
The TX-SV353 comes equipped with
two AA (R6 or UM-3) manganese bat-
teries, but we recommend that long-life
AA (LR6 or AM-3) size alkaline batter-
ies be used when replacing the batteries.
Setting the voltage selector
(worldwide model only)
Setting the AM tuning step
frequency
(worldwide model only)
Using the remote controller
Loading the batteries
PHONO CD TV/AUX TAPE
GND
R
L
R
L
ANTENNA
FM
75 Ω
AM
(PLAY)
INPUT
(REC)
OUTPUT
VIDEO-1
VIDEO-1
INPUT
INPUT
VIDEO-2
VIDEO-2
INPUT
INPUT OUTPUT
OUTPUT
MONITOR
OUTPUT
V V
SUB-
WOOFER
PRE OUT
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
FRONT SPEAKERS
L
L
R
R
REAR SPEAKERS CENTER
SPEAKER L R
A
B
A
B
RATING:
AUDIO VIDEO CONTROL
RECEIVER
MODEL NO.
TX-SV353
120V 220-230V
VOLTAGE SELECTOR
REMOTE
CONTROL
AC OUTLETS
SWITCHED
TOTAL 100W MAX.
10kHz 9kHz
AM FREQ. STEP
MANUFACTURED UNDER LICENSE FROM DOLBY
LABORATORIES LICENSING CORPORATION.
“DOLBY”, THE COUBLE-D SYMBOL AND “PRO LOGIC”
ARE TRADEMARKS OF DOLBY LABORATORIES
LICENSING CORPORATION.
CAUTION: SPEAKER IMPEDANCE
FRONT A OR B: 6 OHMS MIN. / SPEAKER
FRONT A+B: 12 OHMS MIN. / SPEAKER
CENTER / REAR: 6 OHMS MIN. / SPEAKER
PHONO CD TV/AUX TAPE
GND
R
L
R
L
ANTENNA
FM
75
Ω
AM
(PLAY)
INPUT
(REC)
OUTPUT
VIDEO-1
VIDEO-1
INPUT
INPUT
VIDEO-2
VIDEO-2
INPUT
INPUT OUTPUT
OUTPUT
MONITOR
OUTPUT
V V
SUB-
WOOFER
PRE OUT
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
FRONT SPEAKERS
L
L
R
R
REAR SPEAKERS CENTER
SPEAKER L R
A
B
A
B
RATING:
AUDIO VIDEO CONTROL
RECEIVER
MODEL NO. TX-SV353
120V 220-230V
VOLTAGE SELECTOR
REMOTE
CONTROL
AC OUTLETS
SWITCHED
TOTAL 100W MAX.
10kHz 9kHz
AM FREQ. STEP
MANUFACTURED UNDER LICENSE FROM DOLBY
LABORATORIES LICENSING CORPORATION.
“DOLBY”, THE COUBLE-D SYMBOL AND “PRO LOGIC”
ARE TRADEMARKS OF DOLBY LABORATORIES
LICENSING CORPORATION.
CAUTION: SPEAKER IMPEDANCE
FRONT A OR B: 6 OHMS MIN. / SPEAKER
FRONT A+B: 12 OHMS MIN. / SPEAKER
CENTER / REAR: 6 OHMS MIN. / SPEAKER
120V 220-230V
VOLTAGE SELECTOR
10kHz 9kHz
AM FREQ. STEP
30˚
30˚
Insert the batteries into the remote controller according to the illustration.
1 2
3
TX-SV353
Remote controller sensor
STAND-BY indicator
approx. 5 m
(16 feet)