Onkyo TX-SR403, Инструкция по эксплуатации

Страница: 33 / 56

33
First Time Setup —Continued
6
Use the Down [ ] button to
select “Surround,” and then use
the Left and Right [
]/[ ] but-
tons to select Small , Large , or
None .
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7
Use the Down [ ] button to
select “Surr Back,” and use the
Left and Right [
]/[ ] buttons to
select Small , Large , or None .
Small: Select if the surround back
speaker is small.
Large: Select if the surround back
speaker is large.
None: Select if no surround back
speaker is connected.
Notes:
• If the Surround setting in step 6 is set
to None, this setting does not appear.
• If the Surround setting in step 6 is set
to Small, the Large option cannot be
selected.
8 Press the [SETUP] button.
Setup closes.
TESTING THE SPEAKERS
To test that all of the speakers are working properly,
press the remote controller’s [TEST TONE] but-
ton
. The test tone will be output by each speaker in
turn and the name of each speaker will appear on the
display. To turn off the test tone, press the [TEST
TONE] button again.
• If the test tone is not produced by a speaker, or it’s
produced by a speaker other than that shown on
the display, you may have wired the speakers
incorrectly and you should check your connec-
tions (see page 17).
• If the test tone is not produced by a speaker and its
name does not appear on the display, you may
have set the speaker settings incorrectly (see
page 32).
TX-SR403̲En.book Page 33 Friday, April 29, 2005 10:55 AM