Onkyo TX-NR797, Инструкция по эксплуатации

Страница: 150 / 179

150
Front Panel ≫ Rear Panel ≫ Remote ≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
USB Power Out
at Standby
Off When this function is set to "On", electricity can be
supplied to the device connected to the USB port
even if this unit is in standby mode .
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the HYBRID
STANDBY mode where only the essential circuits
operate.
Network Standby On When this function is set to "On", the network
function works even in standby state, and you can
turn on the power of the unit via network using
an application such as Onkyo Controller that can
control this unit.
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the HYBRID
STANDBY mode where only the essential circuits
operate. Note that even if this function is set to
"Off", when any of the HDMI CEC ( p145 ),
HDMI Standby Through ( p145 ), USB Power
Out at Standby ( p150 ) and Bluetooth
Wakeup ( p150 ) functions is enabled, this
function will be in "On" state regardless of the
setting.
• When connection to the network is lost, "Network
Standby" may be disabled to reduce power
consumption. In such a case, turn the unit on by
using the power button on the remote controller
or main unit.
Setting Item Default Value Setting Details
Bluetooth Wakeup Off
This function wakes up the unit on standby by
connecting a BLUETOOTH-enabled device.
"On": When this function is used
"Off": When this function is not used
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption
is minimized by automatically entering the
HYBRID STANDBY mode where only the
essential circuits operate.
• This setting is fixed to "Off" if "Bluetooth" - "Auto
Input Change" is set to "Off".
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be selected. It can
be selected when the network function is activated.
„
5. 12V Trigger
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V
TRIGGER OUT jack. You can enable power link operation when you connect the
unit and the external devices equipped with 12V trigger input jack.
Setting Item Default Value Setting Details
Zone Main Set which zone to output the 12V trigger when
playing. If you select "All", then the 12V trigger is
output to all zones that are playing.