Additional information
6
6
36
Wall-mounting the
Front/Center/Surround
speaker system
CAUTION
•
Use the M5 metric thread screw. Do not use inch thread
screw.
Before mounting
•
Remember that the speaker system is heavy and that its
weight could cause the wood screws to work loose, or the
wall material to fail to support it, resulting in the speaker
falling. Make sure that the wall on which you intend to
mount the speakers is strong enough to support them. Do
not mount on plywood or soft surface walls.
•
Mounting screws are not supplied. Use screws suitable for
the wall material and support the weight of the speaker. If
you are unsure of the qualities and strength of the walls,
consult a professional for advice.
•
To mount the center speaker horizontally, use the two
keyhole slots shown to hang the speaker on two screws
that are securely screwed into the wall.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the
factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down
STEREO
, press and hold
Í
ON/STANDBY
for about two seconds.
3
When you see RESET? appear in the display, press
SURROUND
.
OK?
shows in the display.
4
Press
DSP
to confirm.
OK
appears in the display to indicate that the receiver
has been reset to the factory default settings.
Important
•
If the
Standby Through
is not set to
OFF
, you may not be
able to initialize the unit.
Cleaning the unit
•
Use a polishing cloth or dry cloth to wipe off dust and dirt.
•
When the surface is dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water,
and wrung out well, and then wipe again with a dry cloth.
Do not use furniture wax or cleansers.
•
Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit, since these will corrode the
surface.
5 mm to 7 mm (
3
/16 in. to
9
/32 in.)
Mounting screw (not supplied)
5 mm
(
3
/16 in.)
10 mm
(
7
/16 in.)
130 mm
(5
1
/8 in.)
