14
En
Note
• Push plugs in all the way to make good connections (loose connections can cause noise or
malfunctions).
• To prevent interference, keep audio cables away from power cords and speaker cables.
• The integrated amplifier’s optical digital jack have shutter-type covers that open when an
optical plug is inserted and close when it’s removed. Push plugs in all the way.
• To prevent shutter damage, hold the optical plug straight when inserting and removing.
• Do not use digital audio signals other than PCM.
*
An analog audio cable can be used instead of a coaxial cable. However, we recommend that
you use a coaxial or a composite video cable.
Tip
• To reduce noise, do not tie signal cables together with the power
cable. Wire them so that they are away from each other.
• Depending on the country, the integrated amplifier may be
polarity-sensitive. In this case, plug the power cord in a way that
provides the best sound quality.
Note
•
Never disconnect the power cord from the integrated
amplifier while the other end is still plugged into a wall
outlet.
Doing so may cause an electric shock. Always disconnect
the power cord from the wall outlet first, and then the integrated
amplifier.
• Turning on the integrated amplifier may cause a momentary
power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the integrated
amplifier into a different branch circuit.
• Do not use a power cord other than the one supplied with the
integrated amplifier. The supplied power cord is designed
exclusively for use with the integrated amplifier and should not
be used with any other equipment.
Cable and Jacks
Optical digital audio
(A-9050 only)
Optical digital connections allow you to enjoy digital sound such as
PCM. The maximum sampling rate for PCM input is 96 kHz/24 bit,
2ch.
Coaxial digital audio
*
(A-9050 only)
Coaxial digital connections allow you to enjoy digital sound such as
PCM. The maximum sampling rate for PCM input is 96 kHz/24 bit,
2ch.
The integrated amplifier provides 75-ohm impedance matching.
Analog audio (RCA)
Analog audio connections (RCA) carry analog audio.
u
To use
u
(Remote Interactive), you need to connect your Onkyo
CD Player, Tuner, or
u
Dock to the integrated amplifier with an
u
cable.
Connecting the Power Cord
OPTICAL
Orange
L
R
White
Red
Right!
Wrong!
1
Connect all of your speakers and components.
2
Connect the supplied power cord to the integrated
amplifier’s
AC INLET
. (A-9050 only)
3
Plug the power cord into an AC wall outlet.
AC INLET
To an AC wall outlet
(Plug type varies from
country to country.)
S
upplied power cord
A-90
3
0
A-9050
