Onix T624W100DA2b, Инструкция по эксплуатации

Страница: 14 / 16

Page 14 of 16
Rev 1
10.1 Troubleshooting Table
Problem Cause Remedy
No Power to
Controller / No
Heat Level
Indicator Lights
showing on Front
Display
The Temperature Slide Knob is in the “O” position
Slide the knob to setting 1, 2 or 3. The corresponding
front display Lights should illuminate.
The Power Plug may not be plugged in to the power
point and switched on.
Ensure the power plug is inserted into the power
point correctly and switch on.
There may be no power to the power point
Ensure there is power to the power point. Test with
another appliance such as a table lamp.
No Heat Level
Indicator Lights
showing on Front
Display however
RED indicator light
is showing
through the back
of the controller.
The controller has overheated and blown the Over-
Temp thermal fuse
The Heated Throw elements have been damaged
and a new Heated Throw must be purchased.
The Heated Throw Elements have been damaged.
Heat Level
Indicator Lights
showing on Front
Display but Throw
is not heating
Detachable Plug from Controller to Heated Throw is
not fitted correctly or has come loose.
Ensure the detachable plug is fitted correctly into the
socket on the Heated Throw and the locking tab has
clipped over the lug on the plug.
The selected heat setting is too low. Increase the Heat setting
Pre-heat time is too short.
Allow the Heated Throw more time to heat up.
More time is required depending on the ambient
temperature.
Throw not in contact with Body
The Throw may not feel warm to touch unless it is
wrapped around your body. Areas of the Throw not in
contact will stay cool
Heat Level
Indicator Lights
showing on Front
Display but cannot
change any of the
settings
Program may have locked up to protect itself due to a
power surge.
Unplug the controller from the power point, wait 2
minutes and then plug in and switch on again.
Controller Slide
Knob is in the 1, 2
or 3 heat setting
position but no
Heat Level
Indicator Lights
showing on Front
Display.
The Power Plug may not be plugged in to the power
point and switched on.
Please follow the same steps as under “ No Power to
Controller / No Heat Level Indicator Lights ”
The controller has overheated
Please follow the same steps as under “ No Power
to Controller / No Heat Level Indicator Lights ”
The Auto Off timer has activated and turned off the
Heated Throw.
Heated Throw will automatically turn off after
approximately 3 hours. Slide the Knob to the “O”
position, wait 5 seconds, then select heat setting 1, 2
or 3.
Heat Level
Indicator Lights
Flashing on Front
Display
Controller has Timed Out
Slide the knob to the “O” position to reset then select
the desired heat setting.
Controller is Warm
to Touch
This is normal Nothing to do. Is no cause for alarm.