16
3. Basic Setting
3.1 Check Network and Installation Type
This Chapter is for basic setting of OPN -815/825. To install Hardware of OPN -815/825, basic understanding
of Network is required.
Please refer to Chpater 6 in case knowledge of Network Environment is required.
.
There is two ways to install Hardware,
1.
install OPN -815/825 without IP sharing Device
under Cable Modem or Leased Line,
2.
install OPN -815/825 under IP sharing Device
, which is required under PPPoE environment, and even
under Leased Line or Cable Modem. The default IP Address of OPN -815/825 is preset to 192.168.1.8 and
Subnet Mask to 255.255.255.0 and Gateway to 192.168.1.1 in ex-factory condition. This explanation is based
upon default value of ex-factory.
Caution 1 : Check Video before installation, on ‘
2. Installation and Video Check
’.
Caution 2 : In case using IP sharing Device, only Global IP is available.
Caution 3: OPN -815/825 does not support PPPoE. IP Sharing Device is required to connect to
OPN -815/825 under PPPoE.
Installation without IP sharing device
-> For static IP, refer to ‘
Static IP Setup
’.
-> For dynamic IP, refer to ’
Dynamic IP Setup
’.
Installation with IP sharing device
-> Should set up with Static IP. Refer to
‘
Installation with IP Sharing Device
’
.
3.2 Installation without IP sharing device (Router)
3.2.1 Static IP Setup
1) After checking Video in ‘
Video Check
’, go to the next step.
2) Connect OPN -815/825 to PC with LAN Cable (Cross Cable).
3)
Cable connection and Network Setup should be same as shown in ‘
1. Installation and Video
Check
’.
4) Run Web Browser and input 192.168.1.8 in URL and click ‘Enter’, then [Pic. 3-1] will appear.