Onfloor PRO SERIES 16, Инструкция по безопасности, эксплуатации и список запасных частей

Страница: 5 / 16

P
AGE
5
A A
T TT TA AC CH HM ME EN NT TS S
II
N NS ST TA AL LL LA AT TIIO ON N
& & C C
H HA AN NG GIIN NG G
Before Installation Or Changing
Attachments:
1) Unplug the machine from the wall outlet.
Note: When power is disconnected from machine for
any reason, wait a FULL TWO MINUTES before
reconnecting power. Failure to follow this step may
cause damage to the VFD.
2)
Ensure handle is in the storage position (straight up)
and locked in place with the quick release pin.
3)
Tilt machine back by bracing it with your foot until
the handle is laying on the floor and the three heads
are fully exposed.
Note:
It is recommended that a towel or pad is placed
under the machine to protect the floor.
Changing and Installation of Attachments
When installing or removing attachments, always wear
protective gloves.
1) Position the first attachment head at 12 o’clock.
2)
Using both hands, reach beneath the bottom side of
the attachment and pull up towards yourself to free it
from the machine.
3)
Select the attachment required for the job, and line
up the holes on the attachment with the four metal
pins protruding from each of the three heads.
4) Push attachments on by hand and if necessary, care-
fully tap it into place with a rubber mallet.
5)
Repeat steps 1 thru 4 with the remaining 2 attach-
ments.
6)
Carefully raise the handle, supporting the axle with
your foot to control the head of the machine as it is
placed on the floor.
7)
Since the attachments are different heights, you
may need to adjust the dust skirt to make sure it is
level with the attachments. This will ensure clean and
virtually dust-free operation.
9) To adjust skirt, align the skirt with the center of the
machine and wrap it around.
10)
Move the handle back to the operating position
and lock in place with the quick release pin.
When installing or changing the accessories, turn
OFF
the machine
and disconnect the power cord from the electrical outlet. Wait
at least two minutes before restoring power
CAUTION: