7
Operating Instructions
1)
Clear the floor of any materials or objects.
2)
Select and install the accessory tools required for the job. (See p 8 for installation instructions.)
3)
Move the handle from the lowered “storage” position to the angled “operating” position and lock in
place.
4)
Place your hands on the handle grips and apply slight pressure to lighten the load on the tools.
DO
NOT
lift the tools off of the ground!
5)
Push the start switch toggle forward to “ON” position. Motor will start.
6)
When the machine is running, remove handle pressure and lower completely onto the working
surface.
7)
To stop the machine push, start switch toggle backward to “OFF” position.
Note: If machine unexpectedly shuts down due to a circuit overload, check breaker box feeding the
outlet that the machine is plugged into. TURN MACHINE TOGGLE TO “OFF” POSITION BEFORE
RESETTING CIRCUIT BREAKER.
DO NOT attempt to operate this unit if the machine is not fully assembled. When
servicing or replacing accessories turn OFF the machine and disconnect from the
power source.
Reversing Tool Direction
The tools can be rotated in either direction on this machine. The “Forward” direction is when the cooling
fan on top of the motor is rotating counter-clockwise when viewed from the operator’s position.
The
“Reverse” direction is when the cooling fan rotates clock-wise when viewed from the operator’s
position. There is a toggle switch located on the side of the motor connection box that allows the
operator to select the desired direction. If a change in direction is desired, change the switch position
while motor is off.
All tools supplied by Onfloor can operate in the Forward direction. Some tools supplied by Onfloor can
be operated in either direction. Tools such as 8-way scrapers and Diamabrush tools are designed to
operate in Forward direction ONLY.
If you have questions about tool direction, please contact Onfloor or your Onfloor representative before
using.
Содержание OF9S-L
Страница 12: ...12 ...
