Your EDC LITE kit contains everything you need to install and store the EDC Multi Tool in your stem/steerer
tube and includes the 9 function EDC Multi Tool.
We recommend that you read
ALL
steps of the install process before you begin.
If you are installing EDC LITE on an already assembled bike you do not need to loosen your stem/headset.
If you are building a bike you can still follow all the steps below. But you will need to tighten your headset at the
end of the installation process.
INSTALL INSTRUCTIONS
STEP 1: ENSURE YOUR FORK IS COMPATIBLE - VERY IMPORTANT
Incompatible forks: Giant Overdrive 2 Forks. Cannondale Lefty Forks. Carbon Steerers
STEERER TUBE INNER DIAMETER
The inner diameter of your steerer tube must be at least 24.1mm. OneUp is not currently aware of any tapered
steerer tubes that do not meet this requirement. If fitting unsure, you can check this by inserting the tip of the
EDC Lite into the steerer tube above the star nut BEFORE lowering the star nut position.
STEERER TUBE LENGTH
Most forks are compatible, except for a small number of forks with very short steerer tubes. For the following
cases your fork steerer tube length must meet the minimum length requirement.
Fox except Fox 38 = 190mm min
Fox 38 = 210mm min
RockShox Forks = 210mm min
Measure from the
underside
of your fork crown to the top of your spacer stack, or top of your stem if you are
not running any spacers above your stem.