Oneida Air Systems Supercell XSK000030, Руководство пользователя

Страница: 24 / 34

20º
Oneida Air Systems, Inc. 22
Filter Pulse Bar Cleaning
The Pulse Filter System helps to unclog the filter for
improved airflow and performance. If air flow is not
restored after pulsing, check for clogs and clean filter.
(Review Cleaning the Filter and Troubleshooting Sections).
1. Pulse your filter regularly—including multiple times per day
when collecting fine dust—or when you notice decreased
airflow. Frequent pulse cleaning of the filter will keep your
performance optimal.
2. While the unit is running, close the Blast Gate on the inlet
of the Cyclone. Once closed, push down the Pulse Bar
extending out of the cowling, past the initial resistance, and
hold for a few seconds then release the Pulse Bar. Repeat five
times.
3. Open Blast Gate to resume normal operation.
Cleaning the Filter
When performance has decreased and pulsing has not
recovered enough airflow then the Filter should be
replaced.
1. Wear a dust mask and eye protection.
2. Turn off and unplug the dust collector and wait for the fan
blower to come to a complete stop and for the dust to settle.
3. Unlatch the Ring Clamp (D) at the base of the motor section
and allow it to hang freely. Remove the motor section and
set aside.
4. Use a hand-held, compressed air nozzle with a pressure
between 30 to 60 PSI to blast air along the filter’s exterior
pleating. Hold the air nozzle at a 20 degree angle and at least
6” away from the filter; closer blasts will damage the filter
material. Direct air out and away from anyone in the area.
Do not use this method when any hazardous material has
been vacuumed up.
5. Check to make sure filter is in good condition with no
torn media or cracks or tears in the seal. A broken filter
can leak material into the motor and cause severe damage!
You cannot operate the system without a proper filter in
place. (See Accessories page for the replacement filter part.)
Operating without a sufficient filter will cause severe damage
to the motor and will void the warranty!
Note: To help see damage from the outside, shine a flashlight
from the inside. If the filter is removed after it's been in service
for some time, the gasket may no longer return to it's original
thickness. In this case, ensure enough gasket thickness remains
for proper sealing to prevent dust from escaping.
6. If the filter isn't in good condition, remove the Filter (C) by
removing the four 5/16-18 Nylock Nuts (G11) and the Filter
Hold-Down Ring (B) by sliding it over the filter. Dispose of
the old filter in the same way you would dispose of the dust
you’ve been collecting.
7. Center new Filter (C) over the center of the Cyclone (E)
and place the Filter Hold-Down Ring (B) over the Filter (C)
and re-secure using the four 5/16-18 Nylock Nuts (G11.)
Tighten hardware so that the Filter's pre-installed foam
gasket is firmly compressed (by roughly 50%). DO NOT
OVERTIGHTEN.
8. Replace the motor section and re-latch the drum clamp
around the motor section.
Maintenance
UNPLUG YOUR UNIT BEFORE SERVICING OR CLEANING. KEEP THE TOP VENTS IN THE COWLING CLEAN.
THESE ARE FOR BOTH EXHAUST AND INCOMING COOLING AIR FOR THE MOTOR.
Pulse Bar
Blast
Gate