4 Oneida Air Systems
Assembly Instructions
6
Drill into the wall at all 6 of the marked locations.
7
Place washers onto each fastener and thread the fasteners into all 6 holes, leaving at least 1/2" outside of
the hole. [FIG 1]
Place a mark or drill through the paper at each indicated cross hair. Remove the template from the wall.
Use appropriate fasteners for the wall type you are installing your system onto.
a. Maximum Fastener Size: 5/16" diameter
b. Maximum Washer Size: 3/4" outside diameter
Mark a straight level line on the wall 56" (35-gallon drum) or 68" (55-gallon drum) from the floor.
Note: If you have the Drum Dolly, mark a straight level line on the wall at 60" (35-gallon drum) or 72"
(55-gallon drum) above the floor.
2
4
Temporarily secure the template to the wall with a tack or non-marking tape. Align the top of the
template with the line previously marked.
3
5
FIG. 1
Center the Wall Bracket Template between your wall studs or wherever the Wall Bracket will be mounted.
1
Wall
THE WALL BRACKET SHOULD BE MOUNTED TO A STURDY, REINFORCED WALL (E.G. CONCRETE WALL,
WOOD-FRAMED WALL, ETC.) THE WALL BRACKET IS DESIGNED TO WORK WITH STANDARD 16" STUD
SPACING. WALL ANCHORS CAN BE USED IF MOUNTING ON DRYWALL. THE INCLUDED TEMPLATE
INDICATES THE PROPER DRILL HOLES AND THE FULL, ASSEMBLED SIZE OF THE WALL BRACKET.
1/2"
mm
