20 Oneida Air Systems
Vortex Assembly Instructions (Continued)
Dust pipe or
Purchased Handle
FIG. 23
23
Attach the Clear Cone Assembly (S3) to the
bottom of the Vortex Barrel (S2) and use the 8"
Quick-Clamp (S4E) to secure them together.
[FIG. 23]
24
Remove cardboard ring from the Rubber
Coupling (S4F); you may need pliers to do so
[FIG. 24a].
Remove the pre-installed clamps from the
Rubber Coupling (S4F) [FIG. 24b]. Install
the Rubber Coupling narrow end down, onto
the dust pipe of your floor sander or onto
the purchased handle. The top of the Rubber
Coupling should be level with the top of the
dust pipe. Secure it in place using one of the
Rubber Coupling Hose Clamps (S4F).
FIG. 24a
25
Secure the inlet of the Vortex Barrel (S2)
onto the dust pipe of your floor sander or
purchased handle by sliding the open end of
the Vortex Barrel Inlet Elbow in between the
dust pipe or your purchased handle and the
Rubber Coupling (R4F). Make sure the slot in
the side of the inlet elbow is covered entirely
by the rubber coupling.
The rubber coupler should then be sealed in
place using the Rubber Coupling Band Clamp
(R4G) on the Rubber Coupler. [FIG. 25]
FIG. 24b
FIG. 24c
R4F
R2
FIG. 25