OneAccess One80XM, Руководство по установке

Страница: 23 / 47

One80XM Chapter 4
Installation Guide Interface Description
23
4.1 Connectors of the One80XM Back Panel
The following table gives an overview of the possible connectors located at the back of the One80XM
and explains their function:
Label Function
CONSOLE This RJ45 connector is a V.24 DTE interface. This enables you to manage the
One80XM locally. For more information, refer to
4.6 - Console Port Specifications
on page 28 .
SHDSL This RJ45 connector is the SHDSL line connector.
Connect one side of an SHDSL line cable (not included) to the LINE connector of
the One80XM and the other side to an SHDSL outlet.
For optimum performance, the used line pairs have to be properly twisted
pairs.
Refer to 4.2 - SHDSL Line Specifications on page 24 for the pin lay-out of this con-
nector.
ETHERNET
SWITCH, E0-0/0
... E3-0/3
These RJ45 connectors are the Ethernet LAN connectors. There are 1+4 Ethernet
LAN connectors on the One80XM.
The separate Ethernet interface can be used as main WAN link or as a back-up
WAN link interface. The Ethernet switch is VLAN manageable.
Connect one side of an Ethernet LAN cable (not included) to the LAN connector of
the One80XM and the other side to an Ethernet network outlet. Each LAN interface
supports 10/100 Mbps auto-sense and auto cross-over.
Refer to 4.3 - LAN Interface Specifications on page 25 for the pin lay-out of this
connector.
WLAN The WLAN antennas are installed in the factory. Raise them in a vertical position.
12VDC-2A This is the power input. Insert the plug of the external power supply in this socket.
Secure the power supply connection by installing the DC power supply cord into
the plastic ring provided on the back panel.
Refer to 5.1 - Power Requirements on page 31 for the power specifications of the
One80XM.